Motorcycle Alarm No.7
Circuit : Ron J
Email  :
Web:

Description:
This is a simple motorcycle alarm - with a time limit on the siren. While the thief continues to move the bike - and the normally-open trigger switch continues to open and close - the siren will continue to sound. When the bike stops moving - the siren will cut-off.

If Sw1 is open when the thief abandons the bike - the siren will shut off after about ten seconds. If the switch is closed when the bike is abandoned - the siren will turn off after about a minute. Any subsequent movement will re-activate the alarm.



Notes:
Instead of using a key-switch you can use a hidden switch - or you could use the normally-closed contacts of a small relay. Wire the relay coil so that it's energized while the ignition is on. Then - every time you turn the ignition off - the alarm will set itself.

Sw1 is a single trigger switch that makes and breaks the connection between R1 and ground. You can use a "tilt" switch that will open and close when say the steering is moved - or when the bike is lifted off its side stand. But it should be possible to improvise some sort of simple pendulum device that would be more responsive to other types of movement - and so offer improved protection.

The circuit is designed to use an electronic Siren drawing less than about 500mA. It's not usually a good idea to use the bike's own Horn - because it can be easily located and disconnected. However - if you choose to use the Horn - remember that the alarm's relay is too small to carry the necessary current. Connect the coil of a suitably rated relay to the "Siren" output - and use its contacts to sound the Horn.

The circuit board and switches must be protected from the elements. Dampness or condensation will cause malfunction. Connect a 1-amp in-line fuse AS CLOSE AS POSSIBLE to your power source. This is VERY IMPORTANT. The fuse is there to protect the wiring - not the alarm. Exactly how the alarm is fitted will depend on the make of your particular machine - so I'm unable to provide any further help or advice in this regard.

Veroboard Layout:

Veroboard Layout

Click Here For A Photograph Of The Prototype.

Circuit Exchange International Return to Alarm Circuits http://www.zen22142.zen.co.uk