Guitar Preamp with Tone Controls
Circuit : Andy Collinson
Email  :

Description
An electric guitar pre-amp with tone controls using dual supplies. The guitar pickup is high impedance, therefore good quality screened cable must be used between guitar pickup and the preamp.

Notes
The guitar input is via C1, R1 sets the input impedance of the first op-amp, U1, to 10Meg to avoid any shunting effects. The gain of stage U1 is set by the ratio R2 and R3, C3 controls the high frequency roll-off of the stage.

Tone Controls
The amplified signal is now fed via C4 and control VR1 which should be a logarithmic type potentiometer and acts as a gain control. The signal now passes through a passive Baxendall tone control network, VR2 controlling bass and VR3 controlling treble. VR2 and VR3 are linear type potentiometers.

Tone Controls

As the tone controls are passive, they introduce loss. This is compensated for U2 which is another non-inverting amplifier. With the tone controls set to mid position the response is shown by the blue trace. Overall gain is about 24dB, if more gain is required then the values of R9 and R10 can be changed.

Noise Response
With gain set at maximum and tone controls "flat" i.e. centre position, the noise response is shown below.

Noise Response

Signal to Noise Ratio
With controls set as above the following plot shows how the signal to noise ratio varies with frequency.

Signal to Noise Ratio

Alternative op-amps may be used such as the NE5534, LF351 etc.

Guitar Pickup Wiring
Whilst designing this circuit I found the following page on google:
Guitar ReWiring
This has clear instructions and wiring diagrams of the pickup systems used in guitars.
Circuit Exchange International Return to Music Circuits http://www.zen22142.zen.co.uk