Email: All enquiries
This circuit is designed to amplify the input from a telescopic whip antenna. The preamplifier is designed to cover the
medium waveband from about 550Khz to 1650Khz. The tuning voltage is supplied via RV2, a 10k potentiometer connected to the 12 Volt power supply.
RV1 is the gain control allowing weak signals to be amplified or strong signals to be attenuated. The control voltage is applied to gate 2 of TR1,
a dual-gate MOSFET, the signal voltage applied via gate 1; the input signal being double tuned via the 330uH coil and the two KV1235 varicap
diodes at the MOSFET's input and by the same components at the BF981 MOSFET's drain terminal. Both tuned circuits provide high selectivity
across the entire tuning range. To aid stability the MOSFET stage is fed from a 6.2V zener stabilized supply.
To drive low impedance (50 ohm) receivers, the medium output impedance of the BF981 stage is enhanced by the composite
amplifier made from Q2 and Q3. Q2 is operating in common emitter boosting voltage levels by just over 2, Q3 is
operating in emitter follower providing the circuit with low output impedance.
Finally this active antenna can be used on other bands by changing the values of the 330uH coils. To perform on multiple bands switches or relays can be used to change the value of the coils.