Four small battery-powered transistor alarm circuits - you can build your self - using cheap off-the-shelf components.

Transistor Alarm {D} - Support Material


Transistor Alarm {D} Diagram The Rest of Ron's Circuits Write To Ron More Free-to-Use Circuits Circuit Exchange International

Circuit Description

Click Here For A Photograph Of The Prototype.

Circuit Diagram For A
Transistor Alarm

Learn More About The Complementary Latch

Parts List

Parts List


RS Components

UK & Ireland

Construction Guide

Click here if you're new to constructing stripboard projects.

The terminals are a good set of reference points. To fit them, you may need to enlarge the holes slightly. Then turn the board over and use a felt-tip pen to mark the 4 places where the tracks are to be cut. Before you cut the tracks - double check your marks - to be certain that they are all in the right place

When you're satisfied that the pattern is right - cut the tracks. Make sure that the copper is cut all the way through. Sometimes a small strand of copper remains at the side of the cut and this will cause malfunction. Use a magnifying glass - and backlight the board. It only takes the smallest strand of copper to cause a problem. If you don't have the proper track-cutting tool - then a 6 to 8mm drill-bit will do. Just use the drill-bit as a hand tool - there's no need for a drilling machine.

Transistor Alarm {D}
Construction Guide

Next fit the 7 resistors and the two wire links. Use the wire you've trimmed from the resistors - to make the links. The resistors are all shown lying flat on the board. However, those connected between close or adjacent tracks are mounted standing upright. See The Photograph Of The Prototype.

The next stage is to fit the four transistors, the two capacitors and the diode. The BC557 is the one with the emitter arrow coloured red. Pay particular attention to the orientation of the electrolytic capacitor and the diode. Note that both the positive terminal of the capacitor and the side of the diode with the bar - are pointing upwards.

Turn the board over and examine the underside carefully - to make sure that there are no unwanted solder bridges or other connections between the tracks. If you backlight the board during the examination - it makes potential problem areas easier to spot.

You're Now Ready To Test Your Circuit

Photograph Of
Veroboard Layout
The Rest of Ron's Circuits Write To Ron More Free-to-Use Circuits Circuit Exchange International